Main > Main Forum
Atari "Volcano" Button Help
<< < (4/5) > >>
SirPeale:

--- Quote from: torez on July 13, 2007, 08:11:59 pm ---
--- Quote from: ChadTower on July 13, 2007, 06:46:21 pm ---
I have one in my hand as I post this.   The left set of three have the NC and NO tabs labeled and the right set of two has the ground tab labeled.  It also says they consume 0.1A at -125VAC.

-125VAC?  Odd.

--- End quote ---

These are maximum allowable values.  You have to calculate proper resistance, so the current to the led is <=0.1A.

--- End quote ---

Amps are draw, not output.
Jouster:
Can you still buy these somewhere?  I thought  they were no longer available.

Or are there cheap (or not so cheap) knock offs available?

Jouster
Kevin Mullins:
Here's one source......
http://www.ram-controls.com/order-cones.html

There was an "Atari Cone Button War" going on awhile back about reproduction of these amongst some people. Not sure who all else is still supplying these though.
BrentRadio:
Jouster, did you need the buttons or the cones that go on them?

I have the cones very cheap if you need some.

Brent
Jouster:
I was really more curious than anything...I thought that I had read somewhere that the Atari cone buttons weren't being manufactured anymore.  $20 a button is a bit much...but then again...I don't have a cab to put them in yet.  I'm sure when I start my next project that won't seem so high.

Jouster
Navigation
Message Index
Next page
Previous page

Go to full version