Main > Main Forum
Help With LED-Wiz Wiring Please!
<< < (3/3)
RandyT:

5v operation is what is "supported" because it is very safe.  The drivers on the board can theoretically handle much higher voltages.

Send me an email for more info.

RandyT
Kaytrim:

--- Quote from: lettuce on July 13, 2007, 11:41:01 am ---Thats a real shame, as i have these types of push button as my Player start buttons, and wanted to set them up with LED-Wiz so when you inserted the right amount of credits they would start to flash  :cry:

--- End quote ---

That could still be handled with a relay, you are just turning it off and on.  The LED-Wiz would control the relay and the relay would pass the higher voltage through to the button.
RandyT:

--- Quote from: Kaytrim on July 13, 2007, 11:58:20 am ---That could still be handled with a relay, you are just turning it off and on.  The LED-Wiz would control the relay and the relay would pass the higher voltage through to the button.

--- End quote ---

This would work, but probably isn't necessary.  I have a 12v lamp hooked to a test unit here, right next to a 5v LED connected to the same LED-Wiz board, and both are pulsing and working just fine.  But there are a few cautions that need to be heeded when using it this way.

RandyT

lettuce:
I sent you an email RandyT
Navigation
Message Index
Previous page

Go to full version