Main > Main Forum

illuminated pushbutton help

Pages: << < (2/3) > >>

infamous360:

http://www.outdoorspeakerdepot.com/pgincespico.html right here $100 shipped they are connected to a home theater system with red and white inputs connected to a pc with this cable http://www.bestbuy.com/site/olspage.jsp?skuId=7005457&st=y+audio+cable&type=product&id=1099392032460 the tv is 32" this cab is built for dance dance revolution. I still gotta build the dance pads

btw what is a good graphics card to buy? AGP

fjl:

Well first you have to find out what kind of Video Card your motherboard supports. If its a really old PC it might only work with a PCI video card. Later versions came with AGP slots. After that they now use PCI-E cards. None are interchangeable meaning you can't buy an AGP video card for a PCI-E motherboard and vice versa.

Depending on your computer, it might already have a built in a video card that is perhaps suitable enough to run MAME on. What's your PC?

Dreamwriter:


--- Quote from: infamous360 on July 03, 2007, 11:16:27 am ---i am pretty sure i have the 12s... I have no idea what i need to do... is there a website that will tell me how to wire up the molex? like what kind of wire do i need? etc?

--- End quote ---

Radio Shack sells the connector pins that hook up to those (in a drawer, other drawers generally have different connectors and switches and stuff), you can crimp or solder the wires to them.  Any wire will do - heck, if you wanted to just test it you could even stuff a wire with a bare end into the two holes and then plug in the computer and turn it on.  Just make sure you don't get the polarity wrong (positive goes to the yellow wire, negative to the middle wire (usually black), and that the wire only touches the one hole.

infamous360:

its an older one Compaq p2 40gb hdd, 384 ram. it has an agp slot... I need a card that outputs to TV i dont want to spend alot hopefully less than $80 but if i HAVE too i will spend more... I am upgrading the ram a little bit more (up to 512) and adding 2.0 usb slots



infamous360:


--- Quote from: Dreamwriter on July 03, 2007, 01:32:14 pm ---
--- Quote from: infamous360 on July 03, 2007, 11:16:27 am ---i am pretty sure i have the 12s... I have no idea what i need to do... is there a website that will tell me how to wire up the molex? like what kind of wire do i need? etc?

--- End quote ---

Radio Shack sells the connector pins that hook up to those (in a drawer, other drawers generally have different connectors and switches and stuff), you can crimp or solder the wires to them.  Any wire will do - heck, if you wanted to just test it you could even stuff a wire with a bare end into the two holes and then plug in the computer and turn it on.  Just make sure you don't get the polarity wrong (positive goes to the yellow wire, negative to the middle wire (usually black), and that the wire only touches the one hole.

--- End quote ---
lik
ok i watch this http://www.retroblast.com/articles/coindoor.html what kind of wire do i need? could you send me links?

Pages: << < (2/3) > >>

Go to full version