Main > Main Forum

How do you cut a marquee retainer?

Pages: (1/4) > >>

javeryh:

I just busted up the end of one of the strips trying to cut it with the radial saw - it just cracked into pieces.  Is there an easy way to get a clean/smooth cut?  The plastic is pretty thick...

RetroACTIVE:

I cut mine with a hack-saw... fine enough teeth so as not to bite too much.

northerngames:

dremel cut off wheel

cut with razor close to the desired then sand flush

tin snips may work also

Timoe:

I threw mine at the table saw and it cross cut it like butter.  Nice finished edge ta boot.

I was rockin one of those 80tooth blades but I dont think it really matters if you go slow.


AMDman13:

I wedged mine between two small pieces of scrap MDF and blew through all of it with my circular saw. No prob!

Pages: (1/4) > >>

Go to full version