| Main > Main Forum |
| How do you cut a marquee retainer? |
| (1/4) > >> |
| javeryh:
I just busted up the end of one of the strips trying to cut it with the radial saw - it just cracked into pieces. Is there an easy way to get a clean/smooth cut? The plastic is pretty thick... |
| RetroACTIVE:
I cut mine with a hack-saw... fine enough teeth so as not to bite too much. |
| northerngames:
dremel cut off wheel cut with razor close to the desired then sand flush tin snips may work also |
| Timoe:
I threw mine at the table saw and it cross cut it like butter. Nice finished edge ta boot. I was rockin one of those 80tooth blades but I dont think it really matters if you go slow. |
| AMDman13:
I wedged mine between two small pieces of scrap MDF and blew through all of it with my circular saw. No prob! |
| Navigation |
| Message Index |
| Next page |