| Main > Main Forum |
| Revision of cp design for review |
| << < (2/2) |
| Anubis_au:
what software are you planning on using for the jukebox? |
| gatordad:
--- Quote from: Anubis_au on June 05, 2007, 08:43:44 pm ---what software are you planning on using for the jukebox? --- End quote --- I haven't decided yet, but currently everything I have is organized in itunes. |
| gatordad:
Finally got around to making some changes, what do you guys think? |
| Xiaou2:
The Spinner will be to straining to reach that deep for long durations of play. Instead, try moving it directly above the left players joystick. In fact, you could have dual spinners that way, for dual racing games like Supersprint. Move the 2nd players joys and buttons about 1.5" to the right. That will give more space so that when rolling the trackball very hard - you wont slam into the right players stick on accident. ' Move the trackball up an inch or 2. So that if your have comes in at an angle, you dont accidentally hit the front corner of the cab. Straighten the buttons so that they all line up. Its a common mistake that many curl their buttons to try to adapt to the shape of their fingers would seem to rest. In the arcades, all the buttons are aligned. Also, your keyboard keys are also aligned straight. You simply bend the middle finger a little naturally, so that you are able to fit the shape. If you use a round setup, your middle finger being stretched further will be hitting more diagonally , instead of straight down. This results in loss of power and speed. Also, Ive noticed that you tend to place your fingers in a straight line even if the buttons are curved. This will cause you to hit the wrong part of the buttons (IE: not directly in center). And finally, the space between the buttons should also be very small. Maybe 2mm. Otherwise, you again may hit the wrong part of the button, and or have to stretch your fingers way too far apart to hit all 3 at once. |
| Green Giant:
--- Quote from: Xiaou2 on July 27, 2007, 12:29:00 am --- Move the trackball up an inch or 2. So that if your have comes in at an angle, you dont accidentally hit the front corner of the cab. Straighten the buttons so that they all line up. --- End quote --- Leaving the trackball where it is is probably ok since you need the extra space for Golden Tee; however, you will want to add a lip. Almost all the big panels have a slight extension which will give you some resting space for your palm when on the trackball. The lip also helps divide the panel between players 1 and 2. You can make it straight or curved depending on your woodworking skills. You may have already been planning this but just not shown it on your layout. Also, I second the straight button design. All the great arcade games had the buttons in a straight design, and they probably surveyed doctors and crap like that for the most ergodynamic design so you could continue pumping in quaters without your carpal setting in. Curved fits your hand straightened out, but pressing buttons with the end of a stretched out hand gets very tiresome. Try making a cardboard layout and see for yourself though. In the end what you like is the most important thing. All we can do is comment, its doubtful anyone on here will every actually play on your cab. |
| Navigation |
| Message Index |
| Previous page |