Main > Main Forum

Attatching Glass to an Upright Cab?

Pages: (1/1)

shawnzilla:

What is the best way to install the glass on a LUSID type cab? I would like to be able to remove it without too much trouble, should I need to adjust the monitor, etc...

OSCAR:

See this thread: http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=4057;start=0. This method may be a bit tricky to do with a LuSiD design because of the separte control panel, but it might give you some ideas.

In that thread is linked another thread which discussed this as well.

Mike:

I took the easy route, a glass drill bit and drilled a hole through each corner of the glass. then put screws through it into my bezel. I have these little black things that I got from the home depot that cover the screws. My bezel pulls right out so for me it's really easy to remove.

shmokes:

Pictures!!! I'd like to see how you did this.

SNAAAKE:

--- Quote from: shmokes on April 18, 2003, 05:15:02 pm ---Pictures!!! I'd like to see how you did this.

--- End quote ---
Well here is one if it helps... :)
I took the easy way around as well.

I got the idea from Scott's unicade.
http://home.austin.rr.com/shumate/unicade/

Pages: (1/1)