Main > Main Forum
configure right and left mouse buttons with GGG EI trackball
<< < (3/6) > >>
moriartyds:
Not only that, but it frees up your IPAC inputs for other buttons/functions.
squirrellydw:
I'm back.....I have the GGG electric ice trackball USB, how do I wire two buttons to it to use as mouse buttons?  I am at work right now so I can't look at it.  Are there inputs on it somewhere?

thanks
fjl:
Pretty simple.

ON the bottom of your ICe Trackball, you will find a circuit board with various pins. Right below the Circuit chip it says, M-Buttons and has four pins. Ground L M R.

Simply get a jumper and connect accordingly. Ground to L = Left mouse button. Ground to M = Middle mouse button, etc.
squirrellydw:
what do you mean by a jumper, as in what you use on a hard drive or mother board to set configurations?
RandyT:

The "G" pin is common to all of the switches and the L, M and R pins are LEFT , MIDDLE and RIGHT  mouse buttons respectively.  You would wire the buttons just like you would with any other interface.

RandyT
Navigation
Message Index
Next page
Previous page

Go to full version