| Main > Main Forum |
| HELP!! Electronic coin door mechs :( |
| << < (3/3) |
| grantspain:
look on the side of the credit board where the plug pins are,you will see each pin marked e.g +12,com,meter one of which is coin output,when you find this just link a wire here to your switch decoder credit input connection,i cannot remember the exact pin but i am sure its o/p 1,i know its one of the top 5 pins,get a better photo of the markings and i will tell you |
| Marky_1979:
Yes mate iv looked closer and the symbols are as follows from top to bottom - SW1 SW2 0V O/P2 LAMP 12V ?ET (THE FIRST LETTER IS MISSING NOT SURE WHAT THIS ONE IS) 12V O/P1 0V KEY 12V |
| grantspain:
yes straight forward,what you would need to do is splice another wire onto o/p1(credit line) then connect into coin in on whatever decoder you are using. the letter missing is "m" - its the meter output the credit board needs to be plugged in the credit board can be set to give you any price setting |
| Marky_1979:
Excelllent mate cant thank you enough I will try this. |
| Navigation |
| Message Index |
| Previous page |