| Main > Main Forum |
| Opti-wiz Z Axis |
| << < (2/3) > >> |
| RayB:
Z axis??? Isn't the Z axis the "mousewheel" ? |
| brock.sampson:
Yes that is the mousewheel. |
| Kaytrim:
Try setting the skip rate to 1 or zero in windows for the wheel. That might help with the skipping. If you need to replace the board here is a cheaper option. I have a few of these and they work just fine. TTFN :cheers: Kaytrim |
| RayB:
A mousewheel is typically very low resolution. Try it on one of the other axis first and see if the problem is the same. |
| brock.sampson:
I tried it on one of the connections out of the trackball harness same results. The board itself is bad. Happ is sending me a replacement board. I stole one out of my trackball and the spinner works great on the z axis. I have not changed any settings and it works great. I just need to mount it on the control panel and I'll be all set. I'll just put the replacement board in the trackball. |
| Navigation |
| Message Index |
| Next page |
| Previous page |