Main > Main Forum
Help wiring a Shaffner power entry module
<< < (2/2)
leapinlew:
Hows this look?


As you can see I'm bypassing the fuses (or trying to).
BobA:
Here is the link to the pdf data sheet

Data Sheet

Your connections will power up the power strip with the button on the FN382.   I would check the continutiy of the switch contachs to make sure that they switch as you have wired them before putting the power on the circuit.   I only say this because I do not see the terminals for the switch  with any ID marks on the circuit diagram so I cannot verify your connections on the switch 100%

leapinlew:
ok - I'll try it as soon as I can and report back. Thanks a ton BobA
Navigation
Message Index
Previous page

Go to full version