| Main > Main Forum |
| Trackball Molex Connector |
| (1/1) |
| brock.sampson:
I'm building a spinner out of a happ trackball encoder board. I cannot find the part number for the four pin molex connector that goes to the board. I checked my local Radio Shack and struck out. Does anybody know this part number? Thanks, Brad |
| ahofle:
I doubt you'll find what you're looking for at radio sack unless it's a cell phone. Have you tried looking online? Something like this: http://www.action-electronics.com/molex.htm |
| shardian:
Since it is permanent you can always just solder the connections. No need in adding cost to a cheep spinner. ;D |
| ChadTower:
Or, to compromise, use quick disconnects, and label the wire pairs. |
| Navigation |
| Message Index |