Arcade Collecting > Restorations & repair
Street Fighter 2 Resto!
bfauska:
Thanks for the picture, I suspected that was how it worked but it is nice to have it confirmed. Too bad about the size difference, I guess I'll have to measure extra careful when I do mine. Keep us posted on your restoration.
MaximRecoil:
--- Quote from: bfauska on April 21, 2007, 09:17:39 pm ---Thanks for the picture, I suspected that was how it worked but it is nice to have it confirmed. Too bad about the size difference, I guess I'll have to measure extra careful when I do mine. Keep us posted on your restoration.
--- End quote ---
Oh, it is the other guy doing the restoration, not me. I'm not sure if his is a 25" version like yours or a 19" version like mine, but if his is like yours I'm sure he can get some measurements for you. His *looks* like a 25" (HS-5) to me, with the SFII:WW cardboard bezel cut to fit (SFII:WW bezels were intended for 19" monitor cabinets), so you should be all set once he gets the measurements off his.
bfauska:
OOPS, didn't even notice who posted. Thanks again for the pic, I guess that means that MK3FAN doesn't have to show how the bezel works anymore. The measurements would be nice though.
MK3FAN:
--- Quote from: bfauska on April 21, 2007, 03:04:28 pm ---I just picked up an empty Dynamo HS-5 a while back, mine didn't have the monitor or bezel and I can't quite tell how they would have been mounted originally, could you take a pic of how the bezel is held in? I think I can tell how I would do it, but I don't know how they did it originally. Good luck with your project, some parts of that cabinet look like they will need a lot of work, but mostly it shouldn't be too bad.
Also I am trying to get some good measurements of my cabinet to do a drawing to share with the community, I would like to have some measurements from another cab to compare to. If you get a chance or are taking measurements anyway could you share some info so I can compare and make a more complete drawing? I am not planning on removing as many panels as you see to have removed so you may be able to get some dimensions that would be difficult for me to get.
--- End quote ---
Still waiting on my PCB from ebay. Here are your measurements. Both sides from top right corner to bottom is 72". Both sides from top left to bottom is 64". Both sides from front of control panel to the back of the machine is 30". The bezel area from top to bottom is 8.25". From top of bezel to bottom is 72". Front and back side from across the machine is 27.5. Need any more or clearer details, please let me know. Hope that helps! Oh, also it IS a 25" monitor. I am having a little trouble locating a chassis for it.
bfauska:
Thanks for the measurements, when I get back to drawing mine I'll compare and make sure they seem right, between the two sets I should be able to get accurate results.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version