Main > Main Forum

RAM Controls - Star Wars Yoke

Pages: << < (10/27) > >>

BrentRadio:

Just an FYI...

I just got word from Steven at ArcadeShop that he will be doing another run of the Star Wars marquee overlays with the correct size (the old ones were 1/4 inch too short in the width) in the next few weeks.

Pre order now so these get made quickly!

I just ordered mine.

Brent

Chunce DeLeone:

I have joined the few and the proud to Pre-Order a Yet to be seen Star Wars Yoke,  does anyone have any updates or nuggets of hope to ease the leap of faith which we all have taken?


Breaker:

Hey all,

There is another thread on this subject (not sure how we managed to get two going) in which Havok indicated he had sent off a message to Ram-Controls for an update; I've recently done the same. The last word was that things were very close - the only piece remaining being the handles (currently in for powder coating). If I hear anything I'll report back.

David, if you're on the board, feel free to jump in with an update 'from the source'.

Cheers,
Breaker

Chunce DeLeone:

Thanks for the update!   I CAN"T WAIT!!!!!!!!!!!!

Chunce DeLeone:

How do you guys intrend to interface this to your cabs?  Dual Strike Hack?

Pages: << < (10/27) > >>

Go to full version