| Main > Main Forum |
| RAM Controls - Star Wars Yoke |
| << < (10/27) > >> |
| BrentRadio:
Just an FYI... I just got word from Steven at ArcadeShop that he will be doing another run of the Star Wars marquee overlays with the correct size (the old ones were 1/4 inch too short in the width) in the next few weeks. Pre order now so these get made quickly! I just ordered mine. Brent |
| Chunce DeLeone:
I have joined the few and the proud to Pre-Order a Yet to be seen Star Wars Yoke, does anyone have any updates or nuggets of hope to ease the leap of faith which we all have taken? |
| Breaker:
Hey all, There is another thread on this subject (not sure how we managed to get two going) in which Havok indicated he had sent off a message to Ram-Controls for an update; I've recently done the same. The last word was that things were very close - the only piece remaining being the handles (currently in for powder coating). If I hear anything I'll report back. David, if you're on the board, feel free to jump in with an update 'from the source'. Cheers, Breaker |
| Chunce DeLeone:
Thanks for the update! I CAN"T WAIT!!!!!!!!!!!! |
| Chunce DeLeone:
How do you guys intrend to interface this to your cabs? Dual Strike Hack? |
| Navigation |
| Message Index |
| Next page |
| Previous page |