| Main > Main Forum |
| How do I assign buttons to my Ultimarc 360? |
| << < (2/2) |
| javeryh:
--- Quote from: Havok on April 18, 2007, 11:00:12 am --- --- Quote from: javeryh on April 18, 2007, 09:37:03 am ---Thanks - I was hoping there was some magical solution. Do I have to assign the buttons for every single game? What a pain! --- End quote --- After hitting [Tab], select Input general, and it will set your assignments for all games... --- End quote --- Hmmm... I thought I tried that out last night and the settings didn't keep from one game to the next. I'll give it another shot because that makes the most sense... |
| rockin_rick:
Maybe you could just redo the U360 maps. Then it would send a UP when it's actually being read as DOWN (while you are pushing up). I'd think that the 'input general' would be just as easy. Is there a reason you don't want to rotate the PCB to the correct orientation? I'm guessing - wire routing? Rick |
| javeryh:
--- Quote from: rockin_rick on April 18, 2007, 05:19:57 pm ---Maybe you could just redo the U360 maps. Then it would send a UP when it's actually being read as DOWN (while you are pushing up). I'd think that the 'input general' would be just as easy. Is there a reason you don't want to rotate the PCB to the correct orientation? I'm guessing - wire routing? Rick --- End quote --- Nah, I'm going to flip the U360 the right way. Everything is wired and I thought it would be a problem but then I remembered that I'm an idiot and the harness and USB cable are easliy unpluggable. It shouldn't be a problem. Now all I have to do is figure out how to configure the buttons. |
| rockin_rick:
It may work fine as is (with proper config - I don't know I haven't gotten that far yet...), but if not, then maybe joy2key? Rick |
| Navigation |
| Message Index |
| Previous page |