Main > Project Announcements
Knievel's TT's (Twin Taito's)
Knievel:
Not sure how thick it is Lew, maybe 1/32". Regular 3/4" t-mold was used.
It's just standard laminate, if you were really concerned about it I guess you could go with a thinner vertical grade.
It isn't completely covered by the t-mold but close. Luckily the edge of the laminate is pure black so you really don't notice it. I'll take a pic for you.
leapinlew:
Thanks - this sounds like a great finish. I bet it's faster than priming and painting to.
Do you have an online source or do you just get it at Home Depot? When I looked previously it was around $80 for a 4x8 sheet.
Timoe:
You can grab the formica laminate at your local homey D's or other hardware store usually. $43/sheet
javeryh:
--- Quote from: Timoe on April 16, 2007, 07:14:24 pm ---You can grab the formica laminate at your local homey D's or other hardware store usually. $43/sheet
--- End quote ---
How does it get applied? Is there some sort of sticky backing or do you have to glue it on like a veneer?
Kronos:
I have checked the Depot and lowes stoped selling laminate and the only colors they have left is this awfull looking white or a hunter green marble...still have not found a place to by laminate.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version