Main > Main Forum

2 Questions with pictures

Pages: (1/1)

urbecrisch:

I'll get right to the nitty gritty.

1. What is this (PIC 1) and is it important to use?

2. How would I make this angle cut (PIC 2) on my CP?

Cheers!


destructor:

1. Door switch. If door is open no power to PCB, or power is for test game mode. You can remove this and connect wires from this switch.

NoOne=NBA=:


--- Quote from: urbecrisch on April 15, 2007, 11:54:04 pm ---2. How would I make this angle cut (PIC 2) on my CP?

--- End quote ---

With the board stood on end on a table saw.
Set the rip fence 1/2" or so off the blade, and put the blade at the right angle.
You'll probably need to remove the blade guard to do it, so be careful.

Alternately, you could use a belt sander to do it.

Pages: (1/1)

Go to full version