Main > Main Forum
Integrated cupholders?
pezkore:
The control panel that i am building for my golden tee is going to have a lot of open space on the top (the only things on it are 3 buttons and a trackball). So i was thinking that i would want to install at least one cupholder INTO the control panel rather than attached to the outside of it. That way, my beer would sit down into the control panel (more like a cop holder in a car). my question is, has anyone done this before and does it cause any problems?
OSCAR:
I almost did the same thing on one of my control panels. But for some reason I never got around to installing them before I sold it.
What I was going to use are the marine cup holders. You can normally find them in black or white. Here's a link to ones similiar to what I was going to purchase.
http://www.wolfffishing.com/thmarflusmou.html
Lilwolf:
baa...
what do you think those old 1x - 10x cdrom drives are for??
pezkore:
one concern of mine is that if i put the cupholders in and leave a beer there for too long, and the beer sweats, will that moisture getting into the inside of my CP cause problems (assuming it doesn't get on any wiring)
_Iz-:
--- Quote from: pezkore on April 13, 2003, 03:50:32 pm ---one concern of mine is that if i put the cupholders in and leave a beer there for too long, and the beer sweats, will that moisture getting into the inside of my CP cause problems (assuming it doesn't get on any wiring)
--- End quote ---
Use the ones Oscar shows above, and run a drain hose from it to a container in the bottom of your cabinet (4L milk jug would be good). Problem solved!