| Main > Everything Else |
| ever cut/hurt yourself making your cab? |
| (1/5) > >> |
| paulkortne:
*^%$ I just cut myself routing my cp. I had to use something that looked like a paint scraper to do it, and it slipped. luckly, it doesn't look like i need stiches. |
| Cue-Ball:
I scraped up my hand pretty bad doing the "rough cuts" on my laminate. I was cutting it with a pair of large tin snips and the sharp edges of the laminate did a number on my hand as they rubbed against it during cutting. I'd definitley recommend a good pair of leather gloves when doing any laminating ( or general wood working, for that matter). |
| Brad Lee:
I was drilling a piece of plexi with a 3/8" bit, holding the material in my hand cuz I was just "widening" a hole. Went a little deep and put a gouge in the webbing between my fingers. Ouch |
| RandyT:
I pulled a major bonehead maneuver once while building my first cab prototype. I had a very sharp spiral bit stuck in the collet of my router (CNC router table ;D ) So stupid me, I grab ahold of it with my bare fingers and try to pull it out of the collet. The bit didn't budge, but my thumb slid down the whole length of the sharp edge. Didn't get stitches, but I probably should have ::). The worst part about it was that I was leaving on a family vacation the next morning. I felt like I spent half the time changing bandages. Live and learn. RandyT |
| telengard:
--- Quote from: paulkortne on April 12, 2003, 09:15:29 pm ---*^%$ I just cut myself routing my cp. I had to use something that looked like a paint scraper to do it, and it slipped. luckly, it doesn't look like i need stiches. --- End quote --- Oh yeah, I have. I had my monitor ( which had the casing removed ) hit me on the head when it slipped on the rotating harness I had made. All the solder contacts etc made small cuts on the top of my bald head. Boy was that fun. ;) Be careful out there!! |
| Navigation |
| Message Index |
| Next page |