| Main > Main Forum |
| I've Decided on SpyStyle's DOS CD, so What Hardware for Galaga Only Console? |
| << < (6/10) > >> |
| Kaytrim:
There is more information on the CD here... http://forum.arcadecontrols.com/index.php?topic=58809;all |
| SECONDandBOWERY:
Yeah, I've seen that thread but I just didn't make the connection right away. I'm under the impression that his is more of an installer to put the stuff on a hard drive while the AMOAD is more of a LiveCD (or LiveFloppy or LiveCF, if you will). Is that about right? Rock'n'Roll, --Andy |
| ChadTower:
The cheapest way is probably to use a $15 TV joystick game, with a TV, hacked to your real controls. |
| Kaytrim:
I don't know anything about AMOAD. :dunno For what you want the hardware setup I mentioned above will be more than adequate. You could get by with a card as small as 64 or even 32 MB if you can find one that small anymore. The CF card replaces the hard disk on the computer. This is a faster device than a floppy and the adapter is for an IDE ribbon cable not a floppy cable. So to the computer it is a hard drive. Plug the CF card into the primary IDE connector as the master. Install DOS, MAME and the ROM(s) on the CF card (C:\ drive) from your CD Drive. You can then remove any other drives plugged into the motherboard. Take care of the necessary changes to the BIOS and you are golden. :cheers: One other thing is to edit the AUTOEXE.BAT. The line that starts GameLauncher, the last line needs to be replaced to launch mame with Galaga (mame galag) |
| SECONDandBOWERY:
Oh! That actually sounds much easier than I had anticipated. Rock'n'Roll, --Andy |
| Navigation |
| Message Index |
| Next page |
| Previous page |