Main > Main Forum
Power Supply Repair Guide ??
Luigi:
--- Quote from: Peale on April 05, 2007, 07:50:37 am ---Bad caps are often a cause. I'd start there.
--- End quote ---
What makes me asking: how can I test a cap if it's ok or not ? Do I have to unsolder it for testing or not? You will notice that my electronic abilities are not that good ;)
@grantspain: A german dealer has them for 39€. Even 30€ is too much to throw them all away. We have 3 Quadros in our collection. Each can hold 4 Jamma-PCBs and each PCB is served by a separate PSU.....I think now you understand why I want to repair our supplies ;)
modessitt:
--- Quote ---how can I test a cap if it's ok or not ? Do I have to unsolder it for testing or not?
--- End quote ---
If you have a meter, it may have a cap tester on it. Unsolder the cap and insert into your meter, setting it for capacitance (usually a C) and the next setting above your cap's rating. If you get a short or open, it's probably bad. If you get a value that climbs steadily, it's probably good.
You can eyeball the big caps to see if the tops look like they are bulging or cracked. Sometimes just rubbing the top of them with your finger will pick up some oily residue that stinks. This usually means that cap should me changed because it's blown or is thinking about it. Smaller caps aren't as noticeable, unfortunately.
If you think a different part is blown, you can sometimes find your trouble area by looking at the back side of the board for discolorations like black or brown marks caused by heat. While some parts do heat up naturally (hence the heat sinks) this can give you a starting point for testing parts.
Ken Layton:
http://randyfromm.com/amusements/techdept/ is a very good place to learn. Check out the power supply repair podcasts.
Luigi:
--- Quote from: modessitt on April 05, 2007, 08:46:57 am ---
--- Quote ---how can I test a cap if it's ok or not ? Do I have to unsolder it for testing or not?
--- End quote ---
..... because it's blown or is thinking about it.
--- End quote ---
Nice :D
Thanks for your hints. I'll take a lok at those casts.
I hope to get some experience about that stuff and (with a little help from the experts around) I will write a little tutorial then :)