| Main > Main Forum |
| Electrical problem on shinobi conversion cabinet |
| (1/2) > >> |
| Crax:
I took out my meter last night and went and checked some voltages on the shinobi conversion I have. As seen below in the picture and the writing, I am supposed to get 5v on 4 of the pins, I got 5.08. On two pins I am supposed to get 12 and I got 12.2...but then on the next two pins on the pcb I also get 12.2 and as far as I can tell I should have 0? I get 0 on all the rest as it says. Not quite sure what to do now as I can't really see anything wrong with the wires and am unsure why I am getting 12 on the next pins over. As far as I can tell they aren't touching |
| JeepMonkey:
The coin mech switch isn't wired normally closed is it? Put your meter on the coin mech 1 switch terminal, then toggle the switch. Did the voltage level change? |
| Crax:
I didn't actually have any wires connected to the coin mech's when I ran these checks on the pcb. Those wires were just loose but none were touching each other. Would that make a difference? ??? As you can tell, I am pretty new to this. I'm at work right now, but any suggestions I can try hopefully tonight or tomorrow during the day. |
| Ken Layton:
Your cabinet is wired with 12 volt DC coin counting meters. |
| Crax:
Yes, there is a counter in the cab as well. So nothing to worry about then? Should I be concerned at all that it's 12.2 V instead of 12? Was just afraid of blowing something up yesterday on the board. |
| Navigation |
| Message Index |
| Next page |