Main > Main Forum
How do I wire an Ultimarc 360?
<< < (2/2)
destructor:
If you use USB connection, I-PAC is useless. Connect buttons to U360 PCB, not I-PAC.
javeryh:
Right.  I don't have an iPac for this project so that's why I'm a bit confused on how everything goes together.  I think I got it though - I'm going to wire everything up tonight!
Kaytrim:
Just don't plug it in for long or you will never get the painting done.  :laugh2:

Kaytirm
rockin_rick:
Does anyone know what the pinout of the header is?  Could someone who knows match A-I to the colors in that chart?  What I show as pin 'A' is the missing pin.

(Check out my sweet artwork...)


--- Code: ---
           ---
          (   )      BALL TOP
           ---
            |
            |
            |
-------------------------  MOUNTING PLATE
            |
            |
          -----          MAGNET

       A C E G I
       B D F H J        HEADER
   -------------------    PCB


--- End code ---


Rick
destructor:
Colors are never mind. A is missing. B is ground. C...J are for buttons.
Navigation
Message Index
Previous page

Go to full version