Main > Main Forum

dumb? question - trackball mounting

Pages: << < (3/5) > >>

alandrogers:

I'm a visual guy... thanks u_rebelscum -- that one multicolor picture pretty much explains what I couldn't figure out.

it has to be cutout so the whole mount has to be up right under the plate. got it. thank you very much.

now i understand.

shatter:

For the install of the betson imperial trackball I am using my buddy routed out everything from the underside of the playfield and bent up some aluminum brackets used to mount the trackball to the underside of the control panel. The end result is a completely clean look from the top.





ids:

For that Betson - you had to cut through the panel for the entire area of the thing?  Then it's held in place with the brackets?  And is hiding just under that wood veneer?  If you have any more info or advice - please share.  I need to mount the same thing.

btw - is that some type of LED setup in the bottom-center of the betson (perhaps the GGG offering?)

Kaytrim:

That is not a venier, the whole top is made from a piece of plywood.  The area for the trackball is cut out with a router just leaving a thin piece to hide the case.  The device you see there is the LEDWiz from GGG

ARTIFACT:

thx for all the great info posted here

i am installing mine this weekend :) ... will do a couple of scrap tests first

Pages: << < (3/5) > >>

Go to full version