uroMAMEstyx : Project done (2007.12.10)

Main > Project Announcements

<< < (26/49) > >>

superbigjay:
Small update to say that there's no progress done this weekend...

you see, I'm babysitting my 3 nephews (3, 7 and 9) and let say I don't have much time to spend on my project :badmood:

That make me realize that my "real deadline" is nov 21st, where my girlfriend is supposed to "deliver" our first kid (a boy).

If I'm not done by then, the uroMAMEstyx project will probably last another 3 years...

PS: Is there a way with illustrator to change the corner radius of a rounded rectangle once it is draw?
(I might post in the artwork section if I don't get any answer here...)

Cheers :cheers:
Jay

superbigjay:
hello everyone,

I've put the project on hold this week because I had to work outside my house (remove and install new grass in front of the house). Man my back hurst :'(

This is how the CP will look like... Well the colors aren't right, the light effects aren't right, but the general idea is...

The lizard (uromastyx) laying down on the "project name" is the bast I could do :laugh2:
Hopefully, a friend of mine is working on that part. I'll just have to vectorize it later...

For the marquee, the idea is the same :
- uromamestyx + lizard character

For the two 15" circular side logos:
- the same lizard character player with a joystick (idea is somewhat similar to gamecreatures logo...)

Tell me what you think

Jay :cheers:

theCoder:
Man, I would not want to be the E in that artwork.

superbigjay:

--- Quote from: theCoder on August 13, 2007, 01:20:34 am ---Man, I would not want to be the E in that artwork.

--- End quote ---
right on Coder!!! Neither am I... :laugh2:
I'm still working on me artworks...
A lot of time spent and few progess done....
Learning Illustrator is time consuming...
I wish there were some templates already available...

Jay :cheers:

superbigjay:
Hello Everyone,

This is the latest progress for the uroMAMEstyx...

I've restored my coin door. The door wasn't really in bad shape, but there were some paint chips.

After seeking advice from this community, I tried the black rustoleum spray with hammered finish. I tried it on a test piece and I didn't quite like the result. It was a bit too grey... (dudeman warned me about this)

So what I ended up, was to "smooth" the paint chips using a wire cup brush and leaving as much of the original paint intact. Then, I sprayed a few coats of black paint on it. The result is pretty good and most of all, it preserved the original "bumpy" look.

Then, the other thing I did was to add an opening to pass the wires from the upper part to the bottom...

So here are some pic to illustrate this...

Cheers !
Jay :cheers:

Navigation

 Message Index

Go to full version