Ok, I understand what you all are telling me, but for some reason when I use the white mouse, it always selects the entire polygon
I can't figure this out, can anyone assist me? What am I doing wrong?
here is how the document was created (Illustrator 10)
1) I drew a rough drawing in ms paint (posted above)
2) I opened it in Illustrator, and held down shift and had the pen tool selected and then clicked on each of the joints until it was entirely highlighted.
3. I copied what I had done, and pasted it into a new document (now I have just a polygon)
4. Now if I try to do anything, it selects the entire thing.