| Main > Consoles |
| Xbox 360 Controller Hack Tutorial -- Wireless Hack Now Available!!! |
| << < (19/86) > >> |
| HaRuMaN:
--- Quote from: versapak on August 26, 2008, 03:20:53 pm ---Are the triggers hackable on the 3rd party controllers like the Madcatz? --- End quote --- They are on the Neo-SE, not sure about the Madcatz as I haven't actually done one yet. I would assume yes, normally all you have to do is connect the center pin of the pot to ground (*don't try this unless you know what you're doing, I'm not responsible if you fry your controller / xbox 360 / tv / house / yourself / your cat / your neighbor's cat / etc.) |
| Gatsu:
Silly question. Same steps for rigging up the Guide button? I ask because I need to put the guide button on the joystick I'm building, and need to figure a way to either extend the connection from the actual button to the PCB...and can it wire to just a happ button? or do I need to keep the green/silver button for it? I haven't taken one apart yet, but Im just wondering if thats doable. |
| versapak:
--- Quote from: Gatsu on August 30, 2008, 12:26:18 am ---Silly question. Same steps for rigging up the Guide button? I ask because I need to put the guide button on the joystick I'm building, and need to figure a way to either extend the connection from the actual button to the PCB...and can it wire to just a happ button? or do I need to keep the green/silver button for it? I haven't taken one apart yet, but Im just wondering if thats doable. --- End quote --- Yeah, the guide button is just a regular button. |
| Gatsu:
I went into gamestop today and picked up a cheapo gamestop brand 360 wired controller in hopes of an easier soldering time...less hassle. And I was happy. I cracked the little sucker open, and almost all the contact points are just there out in the open. No dremel work needed. I'll post a diagram once I get everything laid out and whatnot. Should be in the next day or so. No work monday so this is what Im gonna be workin on. w00t. |
| HaRuMaN:
--- Quote from: Gatsu on August 31, 2008, 01:51:19 am ---I went into gamestop today and picked up a cheapo gamestop brand 360 wired controller in hopes of an easier soldering time...less hassle. And I was happy. I cracked the little sucker open, and almost all the contact points are just there out in the open. No dremel work needed. I'll post a diagram once I get everything laid out and whatnot. Should be in the next day or so. No work monday so this is what Im gonna be workin on. w00t. --- End quote --- That's the Madcatz pad. It has a common ground. ;) |
| Navigation |
| Message Index |
| Next page |
| Previous page |