Main > Main Forum
New Product: NovaGem CDR - Coin Drop Replacement Pushbutton
<< < (3/13) > >>
RandyT:

--- Quote from: Kremmit on March 06, 2007, 11:01:38 pm ---I'm assuming these mount in a standard microswitch pushbutton hole?  How wide/tall are the bezels?  I'm wondering if these can replace some existing credit buttons, but there are other buttons mounted nearby.

--- End quote ---

Ok, some dimensions:

First, it's not the same diameter as a standard pushbutton hole.  The threaded portion of the body is 1" long and .925" diameter, or made for a 15/16" hole.  I think 1" would be fine.

The outside dims are 1.3" wide, by 1.96" tall.  The actual button face is .938" wide by 1.588" tall.

They also have orientation pegs to keep them from spinning, so I guess they could be used with existing holes just by putting the smaller peg holes above and below the existing pushbutton hole and then tightening the nut down.  I don't think it will go anywhere, and it should cover everything fine.

RandyT

Jeff AMN:
Nice job. My second cab is going to be riddled with GGG goodies.
ahofle:

--- Quote from: RandyT on March 06, 2007, 11:21:07 pm ---
--- Quote from: Kremmit on March 06, 2007, 11:01:38 pm ---I'm assuming these mount in a standard microswitch pushbutton hole?  How wide/tall are the bezels?  I'm wondering if these can replace some existing credit buttons, but there are other buttons mounted nearby.

--- End quote ---

Ok, some dimensions:

First, it doesn't fit a standard pushbutton hole.  The threaded portion of the body is 1" long and .925" diameter, or made for a 15/16" hole.  I think 1" would work as well, but might be a little sloppy. 

--- End quote ---

 :banghead:
Damn that's a major bummer.  I already have some coin buttons (1 1/8") on the front of my CP.  It would be nice to put these in their place.  Anyone know of any adapters that would help?
RandyT:

--- Quote from: ahofle on March 07, 2007, 12:10:37 am ---Damn that's a major bummer.  I already have some coin buttons (1 1/8") on the front of my CP.  It would be nice to put these in their place.  Anyone know of any adapters that would help?

--- End quote ---


--- Quote from: RandyT on March 06, 2007, 11:21:07 pm ---They also have orientation pegs to keep them from spinning, so I guess they could be used with existing holes just by putting the smaller peg holes above and below the existing pushbutton hole and then tightening the nut down.  I don't think it will go anywhere, and it should cover everything fine.

--- End quote ---

Read this part again :)  I think it will work fine, even in a 1 1/8" existing hole, as long as the orientation pin holes are drilled on center with the existing hole.

RandyT

Tiger-Heli:


--- Quote from: RandyT on March 06, 2007, 11:21:07 pm ---Read this part again :)  I think it will work fine, even in a 1 1/8" existing hole, as long as the orientation pin holes are drilled on center with the existing hole.

--- End quote ---
And not even that precisely on-center, as long as the bezel part of the CDR covered the existing hole.

Another cool product Randy, congrats!!!!
Navigation
Message Index
Next page
Previous page

Go to full version