| Main > Main Forum |
| How do I make square holes for bolts in metal control panel? |
| << < (2/4) > >> |
| ahofle:
--- Quote from: leapinlew on March 02, 2007, 06:23:17 pm ---I recommend Kens method. I do not recommend Fozzys method. --- End quote --- :laugh2: :laugh2: |
| FrizzleFried:
Both Ken and Fozzy are NUTS! Much much too hard to use either of their method! I have found the best way to do what you are asking is to simply drill a hole and use a square file to file it out. Cleanest way to do it by far! ;D |
| rlemmon:
Your all nuts ! He needs to go to lowes and get a square drill bit. ;D |
| johnm160:
A square router bit is much faster and cleaner. ;D |
| FrizzleFried:
Blow torch? |
| Navigation |
| Message Index |
| Next page |
| Previous page |