| Main > Main Forum |
| How do I make square holes for bolts in metal control panel? |
| << < (3/4) > >> |
| Fozzy The Bear:
OK OK I take back my first answer...... The best way to cut these holes is with a "thermal lance" This is a high pressure gas plasma cutter cooled by liquid nitrogen on the end of a 12 foot pole designed for cutting through up to 4" plate steel.... Favoured by large scale safe crackers. Works like a dream. Even cuts great trackball holes. ;) Anyway!!! Who says the hole wants to be square... It's Like So Uncool to be square Dady'o... Best Regards, Julian (Fozzy The Bear) |
| johnm160:
Can I get a cheap one at Harbor Freight? |
| rackoon:
I had a feeling you guys were going to say that. :banghead: So off to Home Depot it is, to buy a square drill bit :angry: |
| johnm160:
Good Choice ;D |
| shardian:
Just use your teeth like normal people. Don't listen to these yahoos. |
| Navigation |
| Message Index |
| Next page |
| Previous page |