| Main > Main Forum |
| How do I make square holes for bolts in metal control panel? |
| (1/4) > >> |
| rackoon:
Like the title says I need to make square holes in my metal CP so my bolts holding my joystick wont spin when I tighten them. I was hoping to use black bolts with no screw driver notch on them. Should I try a file or may by a carbid blade in my jig saw. So how is every one else solving this? :dizzy: |
| Fozzy The Bear:
--- Quote from: rackoon on March 02, 2007, 04:43:35 pm ---Like the title says I need to make square holes in my metal CP so my bolts holding my joystick wont spin when I tighten them. I was hoping to use black bolts with no screw driver notch on them. Should I try a file or may by a carbid blade in my jig saw. So how is every one else solving this? :dizzy: --- End quote --- Drill a hole then file it out square with a square needle file..... It's really quick and easy to do. Try it. Best Regards, Julian (Fozzy The Bear) |
| Ken Layton:
Drill a hole and file it out. That's how I have always done it. |
| leapinlew:
I recommend Kens method. I do not recommend Fozzys method. ;) |
| Fozzy The Bear:
--- Quote from: leapinlew on March 02, 2007, 06:23:17 pm ---I recommend Kens method. I do not recommend Fozzys method. ;) --- End quote --- :dizzy::laugh2: :laugh2: ROFL What is this Lew.... "National Confuse a Newbee Day" LOL ;D Best Regards, Julian (Fozzy The Bear) |
| Navigation |
| Message Index |
| Next page |