Arcade Collecting > Restorations & repair
I don't believe it, another classic added => Centipede ! FINISHED !!!!
Level42:
1) A last look at the original CPO....
2) It's the details...
Level42:
1).....AND the impossible-to-miss things that matter :)
2) OK, let' put some heat to it
Level42:
1) More nudity.... :D
2) Old versus new trackball rollers......
Level42:
1) New bearings installed
2) .....and finaly a use for that red-translucent ball that I intended for my MAME cab.....
It runs as smooth as baby's skin :D
Level42:
OK,worked more on the G07, replaced the flyback, tested, nothing.....this is one ---smurfette--- of a monitor to repair....(see the thread under "monitors".
So, I needed some succes..... I rewired the cable from the monitor connector going to the SCART, this time with the RIGHT connections (DUH !!) and, yes we have a wonderful clean, bright colored picture on the little Philips monitor :) I put it (loosely) in the place where the G07 belongs...resting on the wooden frame really.
So I HAD to hook up the trackball and the button....put back the CP and...........holy crap.....for the first time in my life played Centipede the way it was meant to be !!!!!!!! :cheers: :cheers:
The PCB is running 100%.......now that (&^%#(*$^& G07 needs to get fixed.......I have to admit that I am already tending to getting a used TV-set.......but I gotta leave it a bit for now....will have new courage tomorrow (I hope) ...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version