| Main > Main Forum |
| Button sizes!?! |
| (1/2) > >> |
| AE35:
Hey all! I usually use the Happ comp. buttons, but now I have some control panels that have smaller holes, so they won't fit! Does anyone know where I can get buttons where the 'neck' is a little smaller(width)? Thanks, Nicholas |
| shardian:
Is this what you are looking for? Refer to the schematic at the bottom for hole size. http://www.happcontrols.com/pushbuttons/601200xx.htm |
| AE35:
Well, I'd have to measure first...but it seems that they are only shorter!? I hate too small holes! |
| destructor:
--- Quote from: shardian on February 26, 2007, 09:03:31 am ---Is this what you are looking for? Refer to the schematic at the bottom for hole size. http://www.happcontrols.com/pushbuttons/601200xx.htm --- End quote --- Momentary Contact Pushbuttons looks as Sanwa 30mm. If these have the same size as Sanwa 30mm then are short ad width is bigger than Happ comp. Your holes can be for Sanwa 24mm (24mm diameter) pushbuttons. What is diameter your holes? |
| shardian:
Competition pushbuttons have a 1-1/8" mounting hole. These call for a 0.94 mounting hole. |
| Navigation |
| Message Index |
| Next page |