Main > Main Forum

SLIKSTIK Spinner mounting

Pages: (1/5) > >>

acevedor2:

Ok, this may seem like a really dumb question, but does it matter what direction I mount the spinner.  Meaning, does it matter which way the bracket faces or does the circuit board need to be on a certain side.  Thanks



FrizzleFried:

Uh...yah...it is.  ;D

Think about it...

IT'S A SPINNER!  It twists...around...360 degrees.

....hmmm...

 :dizzy:

PS:  The only question is one not asked...

...and this one!  ;)

patrickl:

Well you have to make sure the spinning knob faces up.

FrizzleFried:


--- Quote from: patrickl on February 24, 2007, 11:48:05 am ---Well you have to make sure the spinning knob faces up.

--- End quote ---

Oh yeah...forgot about that!

 :cheers:

acevedor2:

Yeah, I understand the whole "it's round" concept.  The reason I asked the question is because assuming this uses the same type of interface as a mouse, there is a difference in which way it could be.  In other words if installed one way, right is right and left is left.  If installed the other way, that could be reversed.  I just want to make sure that whatever way I install it, when I spin it to the right, the cursor moves to the right and when I spin it to the left, it goes to the left.  So all smart ass comments aside, anyone have any insight or pics of theirs installed?  As always, thanks for the help.



Pages: (1/5) > >>

Go to full version