Main > Main Forum
Does anyone have a config that I can use or would recommend?
<< < (2/2)
ahofle:
I do 640x480 interlaced on my arcade monitor with the ArcadeVGA.  The ArcadeVGA supposedly also supports 800x600 on arcade monitors, although it is quite a bit overscanned when I try it on my monitor.
DirkDiggler_ESQ:
Now what did I screw up...

I've got Windows set to 640 x 480, made sure that mame.ini had the settings listed earlier, and then ran avres.  In avres, I picked the following options: single screen, 60 hz only, proportional, horizontal, and stretch interlace.

Now when I run Puckman or 1942 via the command line Mame, the top and bottom of the white box that surrounds the initial disclaimer/game info screen is off the top and bottom of the screen.  Shrinking the height of the screen via the monitor controls doesn't bring it back.  How do I fix that?

Thanks!
ahofle:
I haven't figured that one out yet either.  Have you tried manually setting all the available resolutions to see if you can find one that works?  For now, I've resigned to the fact that I have to use hardware stretch (bleh) on some vertical games.  This is one of the reasons I want to look into a multisync monitor, although I'm not sure it will give better results.  You may want to try posting in the monitor forum.
Navigation
Message Index
Previous page

Go to full version