Main > Main Forum
Gorrila Glue = No Bolts for joys
acevedor2:
One question would be how do you recess the holes for the T-nuts. Which bit and what jig. Or would you just try and free hand. I guess I am just a little daunted by the fact that I will be trying to route a recess about 1/2 wide and about 1/16 of an inch deep so the t-nuts fit flush. Does anyone have a good jig setup idea for for this?
I do have the threaded nuts that I can use from below for the other joys, but I have to mount the trigger joy from the top, unless someone knows another way. The base for the trigger joy is metal. One of the things I have considered is chamfer the holes of the base plate so that they can accept a flat head machine screw. Then when I recess the trigger joy flush and mount it, the screws will be flush as well.
Any ideas? Thanks!
acevedor2:
Ok, the more I think about it, the more I realize that you guyts are right (of course you already knew that as you have been doing this for much longer than me :) )
So I have decided how I will mount the other three joys, recessed into the bottom with Pan Head Bolts countersunk up top. What I can't/haven't figured out yet is how to mount the trigger joy. It has a metal mounting plate up top, look slike 16 gauge or so. Recessing the top of the CP for it to be top mounted (which is the only way it will go) is not a problem. The problem is how to hide the bolts that will be used to secure it to the CP.
Any thoughts?
More Cowbell:
Have you thought of trying Gorilla Glue? :laugh2:
acevedor2:
Yep - sure did :cheers:
I was talked out of it (see above thread for details :) )
More Cowbell:
:laugh2: = joke
:dunno