Main > Main Forum
Protective button cover??
<< < (3/5) > >>
MaximRecoil:

--- Quote from: squirrellydw on January 07, 2007, 04:30:08 pm ---This is what I am looking for, would this work, not sure the size since it's in metric

--- End quote ---
That center hole is too small for a standard arcade pushbutton to fit through. It is 22.5mm which is something like 7/8". You need the hole to be 1 1/8" diameter for an arcade pushbutton. You may be able to modify it to work though.
squirrellydw:
grrrrr, anyone wanna fix my link so its shorter?
MaximRecoil:

--- Quote from: squirrellydw on January 07, 2007, 05:04:20 pm ---grrrrr, anyone wanna fix my link so its shorter?

--- End quote ---
You can fix it yourself. Just edit your post and replace it with this link:

http://www.hbcengineeringsolutions.com/pushbuttoncover.htm
squirrellydw:
thanks, much better
woodygjw:
You could put another switch in series with it, whether it be a toggle switch on the side, or another button next to it.  Two buttons would require both to be pressed to activate, or a toggle switch somewhere would allow you to enable or disable the button.
Navigation
Message Index
Next page
Previous page

Go to full version