Main > Main Forum

Only thing left on my cab is to fix the T-ball.. :(

Pages: (1/1)

s8n:

my oscar spinner works fine, and the TB moves up and down, but dosent move in any other direction. i dont know what it could be, the axis' are wired fine, i think. im using an opti-pac, happ TB, winxp.

OSCAR:

Did you try swapping the axis wires to see if you can isolate the problem to either a bad optic board or a broken wire in the harness?  I picked up a brand new Happ trackball not long ago, and mine was doing the same thing.  It turned out to be a broken wire in the harness that I didn't notice until I looked over all the wires very carefully.

If you swap the axis wires and the problem stays on the x-axis, then that could indicate a bad x-axis optic board.  If the problem moves to the y-axis, then you could have a bad wire in the t'ball harness.

s8n:

well, thats what ill have to try, thanks oscar, hopefully its not a bad optipac  :-\

Pages: (1/1)

Go to full version