Main > Main Forum

Mounting question for LCD Top Guns sticks

Pages: << < (2/3) > >>

postalp123:

Thats what I did (See Below)


Firebaall:

Would it not be alot neater to decase the lightstands, and drill the holes with the proper spacing for the  leds on your arcade screen plexi?

These aren't complicated devices.  Just an IR light source.

Fozzy The Bear:


--- Quote from: Firebaall on December 14, 2006, 02:47:10 pm ---Would it not be alot neater to decase the lightstands, and drill the holes with the proper spacing for the  leds on your arcade screen plexi?

These aren't complicated devices.  Just an IR light source.

--- End quote ---

It'd be a lot neater to hide them behind the plexi and no go drilling holes in it. He could drill holes in the Bezel and have the plexi in front of it. That's probably the neatest solution.

Best Regards,
Julian (Fozzy The Bear)

AMDman13:

Sorry to breath new life into an old thread.. I'm thinking of mounting the strips behind the bezel aspostalp123  did. My question is do the LED lights have to shine through also?  What I mean is. Could I just cut a small enough hole leaving just the IR sensors exposed and keep the glowing LED lights hidden behind the bezel?

Whats the purpose of the LED lights on the stand? Can I remove the bulbs?

Fozzy The Bear:


--- Quote from: marlborroman13 on February 20, 2007, 10:55:44 pm ---Whats the purpose of the LED lights on the stand? Can I remove the bulbs?

--- End quote ---

Part of the gun calibration is to shoot at the LED light and because that is the only one you can actually see is lit, it's the only way of telling if the stands have power on them.

Best Regards,
Julian (Fozzy The Bear)

Pages: << < (2/3) > >>

Go to full version