Main > Software Forum
WinIPAC setup - shift keys
<< < (2/2)
Scumgriever:

--- Quote from: Tiger-Heli on December 09, 2006, 05:20:02 pm ---That was sure hard to follow. 
--- End quote ---

Sorry about that, I hurt by back picking up a TV yesterday and I'm on superstrong pain killers and diazapam (Valium) for a few days.  It makes being coherant that much more difficult. but at least I dont care.  ;)

Thanks heaps. That bit you didn't quite get... don't worry. I don't get it either reading back over it.

I have it figured now... I think

in short - there are two shift buttons, one on the P1 & 2 side which can only effect other buttons on the P1 & 2 terminals and one on the P3 & 4 side which likewise can only effect buttons on the P3 & 4 terminals.
Is that right?


Thanks Tiger.




Tiger-Heli:

--- Quote from: Scumgriever on December 10, 2006, 02:57:21 am ---in short - there are two shift buttons, one on the P1 & 2 side which can only effect other buttons on the P1 & 2 terminals and one on the P3 & 4 side which likewise can only effect buttons on the P3 & 4 terminals.
Is that right?

--- End quote ---
Right, but the other key thing is that the "P1 & P2 Side" can be used for any inputs.  So you can connect the lower numbered buttons of Player 3 and Player 4 to say the P1SW4-SW8 and P2SW4-8 and reprogram if you wanted a "P1&2 Side" shift button to affect them also.
Navigation
Message Index
Previous page

Go to full version