| Main > Software Forum |
| Mame 1.08 / Mamewah 1.62b10 and happ USB trackball? |
| << < (2/2) |
| u_rebelscum:
--- Quote from: Minwah on December 07, 2006, 11:49:25 am --- --- Quote from: FrizzleFried on December 07, 2006, 09:47:33 am ---The problem is that your trackball is not your MOUSE DEVICE 0. I assume you also have a mouse hooked up? My cabinet is the same way. My MOUSE is device 0 and my spinner is device 1. I had to go in to the MAME config menu (TAB) and configure my "PADDLE" and my "DIAL" as device 1 (instead of 0). Make sure you modify MAME.INI to read "MOUSE 1". --- End quote --- I am probably a bit out of date with stuff...so is my trackball_device etc advice wrong? I think it is correct, but you then just have to be careful of any mouse-device-specific input mappings. --- End quote --- No you're correct. Sounds like he had to remap his mouse device inside mame. |
| Minwah:
--- Quote from: u_rebelscum on December 07, 2006, 02:07:54 pm ---No you're correct. Sounds like he had to remap his mouse device inside mame. --- End quote --- Thanks for confirming that :) |
| Navigation |
| Message Index |
| Previous page |