Main > Main Forum

New Product: TurboTwist 2 - The Ultimate Spinner / Paddle control ! From GGG!

Pages: << < (31/62) > >>

Fozzy The Bear:


--- Quote from: RandyT on December 02, 2006, 01:37:10 pm ---Here's an example of the "semi-premium" spinner knobs I mentioned.  These will be separate order items and I have a few other styles / designs, including some very Tempest-like knobs.

--- End quote ---

Wohhhhh! Randy!! Those are absolutely awesome!!......  Only one question?? Will you be able to offer one off custom designs???  I'm guessing that you have to order these in bulk so I'm guessing the answer will be no. But I thought I'd ask anyway.

Best Regards,
Julian (Fozzy The Bear)

RandyT:


--- Quote from: Fozzy The Bear on December 03, 2006, 06:01:44 am ---Wohhhhh! Randy!! Those are absolutely awesome!!......  Only one question?? Will you be able to offer one off custom designs???  I'm guessing that you have to order these in bulk so I'm guessing the answer will be no. But I thought I'd ask anyway.

--- End quote ---

Actually, I did the vectorization and cutting of these myself.  Custom stuff will take more time and would have a cost associated with them, but if the art is already vectorized and not too detailed, it shouldn't be too bad.  I'll see what I can do.

RandyT





Fozzy The Bear:


--- Quote from: RandyT on December 03, 2006, 10:34:03 am ---if the art is already vectorized and not too detailed, it shouldn't be too bad.  I'll see what I can do.

--- End quote ---

That's great! thanks Randy.... It's about time I started to learn to vectorize artwork anyway... LOL I've got a good excuse now  ;D

Best Regards,
Julian (Fozzy The Bear)

Kremmit:


--- Quote from: whammoed on December 01, 2006, 03:43:12 pm ---
--- Quote from: Aurich on December 01, 2006, 01:02:00 pm ---
--- Quote from: Kremmit on December 01, 2006, 12:19:32 am ---Exacto the overlay, then holesaw the wood?

No, wait... clamp a piece of scrap wood on top of the CP first, sandwiching the overlay.  Holesaw through the sandwich.

--- End quote ---

It's a metal CP (Galaga style), and the problem is the heat during the drilling bubbles the polycarbonite and the vinyl. I've tested it on scrap before. So ya, some exacto work will probably be required if I do it.

--- End quote ---

you need a greenlee hole punch, find a used one on ebay for cheap

--- End quote ---

Oh, metal CP.  Whammoed is right.  No heat, no drilling, no bubbles.

subcriminal:

Hi, I hope I did this right as I'm in the UK, suppose I should have asked first. I just ordered a TurboTwist 2 slave as I have an optipac in my cab, I take it the master one just includes the interface board so will a slave be ok through the optipac? I also chose USB1 as the device number as It'll be the only USB peripheral plugged into the motherboard.

Cheers.

Pages: << < (31/62) > >>

Go to full version