| Main > Main Forum |
| Spinner is reversed |
| << < (2/2) |
| Zeppo:
yeah, after some sleep, the next morning I started looking at the wires coming from the mouse. There are only 5. One for ground, one for voltage, then 3 more. In those three would need to be a clock signal, movement data, and mouse click signal. Just a guess. So there aren't wires for left/right, up/down like I was hoping. I was trying to figure out a way to turn the board upside down, but there wasn't enough room, so I may go with extending the decoder wheel later, thanks Kremmit. I'll just stick with the software option originally mentioned by Vizzinni, but if you can find the info on the logitech software, I'll try that Sev. Thanks all. |
| Thenasty:
here is all you need to do: On the sensor there are 3 wires (soldered) where you encoder wheel is. all you need to do is un-soldered the left and right leave the middle alone and using a wire to re-soldered it but the left now will be solderd to right and right to left..hope made sense.... Make sure bend the legs out so it won't be touching the original soldered spot and re-solder the wire into the legs. or if you like, maybe its better too, trace the line and cut it (exacto knife) making the line open and solder a wire from the spot and re-solder it to the oposite side....hope you see the picture... |
| Navigation |
| Message Index |
| Previous page |