Main > Main Forum
Ultrastik 360 in 3/4 panel
<< < (2/4) > >>
fatfingers:


--- Quote from: squirrellydw on November 14, 2006, 02:44:06 pm ---How much longer are the long shafts?

--- End quote ---


--- Quote from: ultimarc order page ---Optional 10mm longer handle.
--- End quote ---

For the metric impaired (like me), I believe that is  0.39370 inches.  That's not really useful either, so my funky math conversion puts it a little larger than 3/8" (0.375 inches).

rdowdy95:
Hey Donkey Kong how far did you rout and also what length screws did you use.  Were they wood screws flat/rounded?  also did you use a washer for them as well?  I have 3/4" birch.  One other question what size joystick hole did you decide to go with?  1 1/8" or maybe 1 1/4" round to stick the stick through?
javeryh:

--- Quote from: fatfingers on November 14, 2006, 02:55:35 pm ---

--- Quote from: squirrellydw on November 14, 2006, 02:44:06 pm ---How much longer are the long shafts?

--- End quote ---


--- Quote from: ultimarc order page ---Optional 10mm longer handle.
--- End quote ---

For the metric impaired (like me), I believe that is  0.39370 inches.  That's not really useful either, so my funky math conversion puts it a little larger than 3/8" (0.375 inches).



--- End quote ---

So if you route a 3/8" deep hole underneath the CP it will be the same as buying the longer shaft?  Sweet - that saves me $12 or so!
fatfingers:


--- Quote from: javeryh on November 14, 2006, 03:51:55 pm ---So if you route a 3/8" deep hole underneath the CP it will be the same as buying the longer shaft?  Sweet - that saves me $12 or so!

--- End quote ---

It does appear that way.  That said, if you have a solid wood control panel that might be just fine, but I don't know how strong (3/4" - 3/8" =  3/8") MDF would be for mounting joysticks (with what are now very short screws).

squirrellydw:
And can someone tell me what this is used for??  UltraStik Button / Encoder Harness

I don't plan on using a encoder for the 3rd CP on my cocktail table but I will have buttons on it.  Can I just wire the buttons to my ipac and not use it or would it be better to use the UltraStik Button / Encoder Harness

Navigation
Message Index
Next page
Previous page

Go to full version