Main > Main Forum
Happ perfect 360 , It's making a crunching noise.
kowal:
pivot cracks and funnel on bottom.
http://forum.arcadecontrols.com/index.php?topic=52951.0
Keypel:
ok, I know (I think I know) why it's making that snapping crunchy noise (see pic below)
When I remove the optical hub, the crunchy noise stops.
Have no idea how to fix it.
kowal, I'm reading that thread now......
Keypel:
ok, Seems that we all agree that the crunchy noise is caused by the plastic piece that sits between the spring and the actuator rubbing against the optical hub.
Had to study the hell out of this picture (below) by kowal/2600 before it made any sense.
According to the picture above, It looks like a taller actuator will move that other piece further away from the optical hub. I have no idea on how to *make* a taller actuator.
Some other solutions I thought of would be to add a small washer between the E-clip and the actuator. Another one might be to add spacers between the main housing and the optical hub.
What do you guys think?
I take it that everyone that owns a perfect 360 has this problem??
I can't belive the makers of perfect 360 would allow such a design flaw!
kowal:
funnel hinders about hub but the bang of spring generates pivot (is too wide).
if you have not different pivot. use sticking plaster
taste to to wrap around stick tape.
P360 has a lot of constructional mistakes- Wico base is total crap. This is old construction.
--- Quote ---I take it that everyone that owns a perfect 360 has this problem??
--- End quote ---
everyone...
some men this does not disturb. they are exacting little.
http://forum.arcadecontrols.com/index.php?topic=57724.0
miles2912:
I have 2 perfect 360's in my cab with absolutely no problems or noise. If yours is defective Happs will replace them. These are top of the line sticks and should operate as such. My gut says you put them together wrong but it sounds like you are ok there. They should be whisper quiet.
D-