Main > Main Forum
neo geo machine will not turn even after i put in a new power supply..
(1/3) > >>
robot8319:
i am having a lotof trouble with my neo geo machine..

here is the problem.

i though it was the power supply i put in the newone made sure it was put in correctly and made sure all cables and harness was secured..

i flipped the switch and i got nothing..

please tell me what to look for i see a fuse right below the monitor..could that be causing the machine to not turn on??

is it safe to change the fuse or do i have to get a pro to do it??
RayB:
You can change fuses yourself, so long as you're smart enough to do it when the machine is NOT PLUGGED IN!

Here's another thought though: look for one of those WHITE switches that looks like this: http://www.happcontrols.com/powersupplies/53703100.htm

Pull on the tube part sticking out. Pull so it clicks out. Now try powering on the machine.



ChadTower:

Yep, check the power cutoffs at the coin door and the back door... make sure they are both either pushed in or pulled all the way out (they click into position).

Of course, if they are not both there, you may have found your cause.
BobA:
If you used an atx supply did you short pin 14 (PS_ON) with one of the grounds.

robot8319:
i am using a real jamma PSU..and i see three holes where fuses go what kind do puti n there??

3 amp 125v?
Navigation
Message Index
Next page

Go to full version