Main > Main Forum
Rebuilding trackballs
<< < (3/4) > >>
_) (V) (-):
Yes Sharidan, and that is a really good idea, but the problem is that there are portions of the top casing that actually hold the bearings down into their slots, attempting to keep them 'level' with the top edge of the lower casing.  I didn't want to modify the casings any but, it may not be that big of a deal. I've got a couple to work with here.  I'd really like to clean up the action on this thing before I cut up my control panel and install it.
Guess I have to do something cuz I just don't like touching sloppy balls!
 :laugh2:
(hey, someone had to say it)
RayB:
No, the green wire is just a ground.

Maybe someone put a billiards cue ball of the wrong size in there. It should be 2 1/4".

_) (V) (-):
Ya'kno, it does look like a cue ball, but it was just a typo, I ment to say (I mean type) 2 1/4" there.

The size difference is very small, like 1/16th of an inch. But it is enough to make the thing hop around in the casing if you really get on it.
shardian:
Where would you get a cue-ball of non-regulation size anyways??? Reg. is 2-1/4"
_) (V) (-):
eBay?
They got everything else . . .
Navigation
Message Index
Next page
Previous page

Go to full version