Main > Main Forum
Taito Cocktail Plans *Sketch inside*
Bill Mote:
--- Quote from: Havok on October 25, 2006, 09:08:40 am ---http://pdf.textfiles.com/technical/pacct-instructions.pdf
--- End quote ---
That's beautiful!
dot
johnm160:
--- Quote from: hbm*rais on October 25, 2006, 10:09:00 am ---Thank you for the link, Havok, but I think that's the Midway SI. I'm actually looking for this style of cab:
--- End quote ---
I own that style cabinet, however it is nowhere near as nice as in that pic. What do you need to know?
Edit to fix pic:
hbm*rais:
--- Quote from: johnm160 on October 25, 2006, 10:41:18 pm ---What do you need to know?
--- End quote ---
Well... Everything ;D!
Just Kidding. I don't want to impose on you too much. What I'd like to know is the basic external measures of the upper and lower box.
I already know (from the flyers archive) the size of the top and the total height so those are covered.
About the lower box, is it completely made of wood, or is it a combination of a wood frame covered with steel sheet? I've got different impressions from different photos.
I also would like a close up picture of the joint in the corner of the upper box.
Man, really, if you don't have the time for any of this, I completely understand. Whatever information you can put together will be greatly appreciated.
danny_galaga:
the ones ive seen, the bottom section is made of fibreglass. you could make a reasonable job out of mdf i think, although fibreglass is thinner and thus more room for the goodies inside (",)
if only you could get hold of chablis97:
http://forum.arcadecontrols.com/index.php?topic=33042.0
his efforts would have been perfect for what you need.
johnm160:
--- Quote from: hbm*rais on October 26, 2006, 12:14:00 am ---
--- Quote from: johnm160 on October 25, 2006, 10:41:18 pm ---What do you need to know?
--- End quote ---
Well... Everything ;D!
Just Kidding. I don't want to impose on you too much. What I'd like to know is the basic external measures of the upper and lower box.
I already know (from the flyers archive) the size of the top and the total height so those are covered.
About the lower box, is it completely made of wood, or is it a combination of a wood frame covered with steel sheet? I've got different impressions from different photos.
I also would like a close up picture of the joint in the corner of the upper box.
Man, really, if you don't have the time for any of this, I completely understand. Whatever information you can put together will be greatly appreciated.
--- End quote ---
Well as I remember the bottom is metal.....It is currently at my inlaws garage, I will be over there today or tomorrow, I will measure it for you.
:cheers: