| Main > Main Forum |
| Taito Cocktail Plans *Sketch inside* |
| << < (5/5) |
| johnm160:
--- Quote from: hbm*rais on October 31, 2006, 07:37:56 am ---Hi John, Yes, I saw that picture after posting. I should have edited my post :-[, sorry. I have all the information I need for myself right now, but if you want to take some measurement of the CP's opening and the coin box opening, I can add it to the sketch for completeness sake. It may be useful for someone else. Thanks again for everything! --- End quote --- Nothing to be sorry for.... ;D I should be over there today I them while I am there. :cheers: |
| londonbabe:
Here's some plans I made when intending to scratch build a cabinet. (in the end I converted one instead) It's not exact size of a Taito cab cos the measurements are altered to fit a 17 inch NEC FE700 monitor I was going to use. (and I never tried making a scale model or anything, so some measurements might be wrong) |
| johnm160:
--- Quote from: hbm*rais on October 31, 2006, 07:37:56 am ---Hi John, I have all the information I need for myself right now, but if you want to take some measurement of the CP's opening and the coin box opening, I can add it to the sketch for completeness sake. It may be useful for someone else. Thanks again for everything! --- End quote --- Ok, The cp opening is 14 1/4 x 5 5/8 and starts right at the very bottom, there is no material under the cp on the front panel it sits on the bottom board. The Coin box opening is4 3/4 x 5" inside and 6"x6" to the outside of opening that the box sits in. Also it is 9" deep. |
| Navigation |
| Message Index |
| Previous page |